Buick Encore: Automatic Transmission Shift Lock Control Function Check
Warning
When you are doing this
inspection, the vehicle could
move suddenly. If the vehicle
moves, you or others could be
injured.
- Before starting this check, be
sure there is enough room
around the vehicle. It should be
parked on a level surface.
- Apply the parking brake. Be
ready to apply the regular
brake immediately if the vehicle
begins to move.
- With the engine off, turn the
ignition on, but do not start the
engine. Without applying the
regular brake, try to move the
shift lever out of P (Park) with
normal effort. If the shift lever
moves out of P (Park), contact
your dealer for service.
Park Brake and P (Park)
Mechanism Check
Warning
When you are doing this check,
the vehicle could begin to move.
You or others could be injured
and property could be damaged.
Make sure there is room in front of the vehicle in case it begins to
roll. Be ready to apply the regular
brake at once should the vehicle
begin to move.
Park on a fairly steep hill, with the
vehicle facing downhill. Keeping
your foot on the regular brake, set
the parking brake.
- To check the parking brake's
holding ability: With the engine
running and the transmission in
N (Neutral), slowly remove foot
pressure from the regular brake
pedal. Do this until the vehicle is
held by the parking brake only.
- To check the P (Park)
mechanism's holding ability:
With the engine running, shift to
P (Park). Then release the
parking brake followed by the
regular brake.
Contact your dealer if service is
required.
READ NEXT:
Windshield wiper blades should be
replaced periodically. See
Maintenance Schedule
Replacement blades come in
different types and are removed in
different ways. For proper type and
length, see Maintena
Driver Assistance Systems
When a windshield replacement is
needed and the vehicle is equipped
with a front-looking camera sensor
for the Driver Assistance Systems,
the windshield must be installed
acc
SEE MORE:
DIAGNOSTIC INFORMATION AND PROCEDURES
SQUEAKS AND RATTLES
NOTE: Squeaks and rattles are caused by improperly controlled
relative motion
between vehicle components. There are 4 ways to prevent squeaks and
rattles.
Attach the component that squeaks or rattles securely.
Separate the components that
For the proper type of replacement
bulbs, or any bulb changing
procedure not listed in this section,
contact your dealer.
Caution
Do not replace incandescent
bulbs with aftermarket LED
replacement bulbs. This can
cause damage to the vehicle
electrical system.
Halogen Bulbs
Warning
Halogen bulbs have