Buick Encore: Bolted Exterior Body Panels and Closures
Buick Encore 2012-2019 Service Manual / Accessories & Equipment / Bolted Exterior Body Panels and Closures
- Bolted Exterior Body Panels and Closures - Diagnostic information and procedures
- Bolted Exterior Body Panels and Closures - Repair instructions
READ NEXT:
Bolted Exterior Body Panels and Closures - Diagnostic information and
procedures
DTC B3006: Hood ajar circuit
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
SCHEMATIC WIRING DIAGRAMS
HOOD LATCH WIRING SCHEMATICS (ENCORE)
Hood Latch
Fig. 1:
Bolted Exterior Body Panels and Closures - Repair instructions
Front end upper tie bar replacement
Fig. 3: Front End Upper Tie Bar
Front End Upper Tie Bar Replacement
HOOD PRIMARY LATCH RELEASE CABLE REPLACEMENT (Encore)
Fig. 4: Hood Primary Latch Release
SEE MORE:
Engine oil and oil filter replacement
Removal Procedure
Open hood.
Place a drain pan below the vehicle.
CAUTION: To prevent damage to oil filter cap ensure proper tool is
used. Do not
use an open end wrench which may cause damage to filter cap.
Using a 24mm socket or closed end wrench loosen oil filter cap. Unscrew
filter cap 3
Engine Heating and Cooling - Repair instructions
Cooling system draining and filling
Draining Procedure
WARNING: To avoid being burned, do not remove the radiator cap or
surge tank
cap while the engine is hot. The cooling system will release scalding
fluid and steam under pressure if radiator cap or surge tank cap is
removed while the engine and
© 2020-2025 Copyright www.bencore2.com
