Buick Encore: Compact Spare Tire
Warning
Driving with more than one compact spare tire at a time could result in loss of braking and handling. This could lead to a crash and you or others could be injured. Use only one compact spare tire at a time.
If this vehicle has a compact spare tire, it was fully inflated when new; however, it can lose air over time.
Check the inflation pressure regularly. It should be 420 kPa (60 psi).
Stop as soon as possible and check that the spare tire is correctly inflated after being installed on the vehicle. The compact spare tire is designed for temporary use only.
The vehicle will perform differently with the spare tire installed and it is recommended that the vehicle speed be limited to 80 km/h (50 mph). To conserve the tread of the spare tire, have the standard tire repaired or replaced as soon as convenient and return the spare tire to the storage area.
When using a compact spare tire, the AWD (if equipped), ABS, and Traction Control systems may engage until the spare tire is recognized by the vehicle, especially on slippery roads. Adjust driving to reduce possible wheel slip.
Caution
When the compact spare is installed, do not take the vehicle through an automatic car wash with guide rails. The compact spare can get caught on the rails which can damage the tire, wheel, and other parts of the vehicle.
Do not use the compact spare on other vehicles.
Do not mix the compact spare tire or wheel with other wheels or tires.
They will not fit. Keep the spare tire and its wheel together.
Caution
Tire chains will not fit the compact spare. Using them can damage the vehicle and the chains. Do not use tire chains on the compact spare.
READ NEXT:
Jump Starting
Jump Starting - North
America
For more information about the
vehicle battery, see Battery - North
America
If the battery has run down, try to
use another vehicle and some
jumper cables to start your v
Towing the Vehicle
Caution
Incorrectly towing a disabled
vehicle may cause damage. The
damage would not be covered by
the vehicle warranty. Do not lash
or hook to suspension
components. Use the proper
straps around the
SEE MORE:
Seat Hardware, Trim, and Upholstery - Repair instructions
Driver or passenger seat removal and installation
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
DIAGNOSTIC INFORMATION AND PROCEDURES
MANUAL SEAT ADJUSTER LOCKS BETWEEN LOCK POSITIONS
Manual Seat Adjuster Locks Between Lock Positions
SEATS - ADJUSTER TRACK
Power Seats
SCHEMATIC WIRING DIAGRAMS
DRIVER SEAT WIRING SCHEMATICS (ENCORE)
Power Seat (Without AAG) and Lumbar
Fig. 1: Power Seat (Without AAG) and Lumbar
Module Power, Ground, Serial Data, and Memory Controls (AAG)
Fig. 2: Module Power, Ground, Serial Data, and Memory Controls (AAG)
Seat Adjuster Switch
